Ep. 2 How do you align the photocells? - Photocells | BENDING WITH VICLA

Hi, welcome to “Bending with VICLA” Youtube series. Today we will explain you how to align the photocells. Before we start, don’t forget to like this video, subscribe to the channel and hit the notification button. The left photocell is the laser transmitter, the right photocell is the camera receiver. To align the photocells, you must use the appropriate align tools: ▶️ For the laser transmitter we will use the TX Alignment Magnet; ▶️ For the camera receiver, we will use the RX Alignment Magnet; The first thing to do is to raise the laser transmitter bracket until it’s over the punch by unlocking the mechanical pin; ▶️ Apply the TX Alignment Magnet on the end of the punch with the punch tip aligned to the tool tip mark; ▶️ Now let’s move to the camera receiver; place the RX Alignment Magnet on the end of the punch with the punch tip aligned to the tool tip mark; ▶️ Power up the photocells system and check the laser beam alignment on the transmitter side. The position of laser beam must not exceed the right-most dashed red line guide displayed on the align toll; ▶️ To adjust the position, loosen the screw by using a 6mm hex key and adjust then horizontal position of the camera transmitter; ▶️ The laser will now strike within the rectangular window reception area; ▶️ Use a 10mm wrench to further adjust the position of the laser transmitter until the laser beam centers perfectly the black rectangle displayed on the RX Alignment Magnet; ▶️ When the alignment is completed, remove both the magnets; ▶️ Check that the receiver photocell is correctly aligned by pressing the “Test” button; ▶️ The check is underway when sensors are blinking. When lights turned off, except for the power light, the alignement check is successfully completed. Thanks for watching! If you liked the video, please hit the like button; if you want to see more videos, hit the subscribe button; and if you have something to say, please leave a comment! Bye until our next video! ​ #pressbrake​ #photocells #sheetmetalmachine​ #viclasheetmetalmachine #carpentery​ ======================================================= ? Subscribe to our YouTube Channel https://www.youtube.com/ViclaPiegatrici​ ? Visit our Website http://www.vicla.eu/it​ Follow us to our social network ? ➡ Linkedin https://hubs.la/H0xyl7Z0​ ➡ Facebook https://hubs.la/H0xyjws0​ ➡ Instagram https://hubs.la/H0xyl6X0​

© 2021 Fiera Milano SpA - P.IVA 13194800150
An error has occurred